Washington DC Stone and Brick Buildings Vulnerable to Distant Quakes

New study shows that DC geologic conditions strongly affect earthquake shaking.

save_alt Download PDF


On August 23, 2011 a magnitude 5.8 earthquake in Mineral, Virginia rattled Washington, DC, 130 km (81 mi) away, and caused some tens of millions of dollars in widely-publicized damage. Prominent among the damaged buildings and structures were concentrated damages to the pyramid top of the Washington Monument; the Sherman Building at the Armed Forces Retirement Home; parts of the Washington National Cathedral such as the flying buttresses and spires; and the chimneys and other small parts of the Smithsonian “Castle”. Minor damage around the city included cracked masonry and chimneys, other broken architectural elements, and toppled gravestones.

How could a moderate-sized earthquake so far away cause so much damage?

An earthquake of the same size in the Eastern U.S. is felt more widely than one in the Western U.S. because seismic waves travel further in the colder, denser crust of the Eastern U.S.

Older, denser crustal rocks allow earthquake wave energy to travel greater distances in the central and eastern parts of the United States than through the younger, less consolidated rocks in the western part of the country. It’s also well known that older stone and brick buildings and other unreinforced structures, which are more prevalent in the east than in the west, are more susceptible to shaking damage from an earthquake. But even so, the observed damages in some of the structures, and even the citizen-science reports in the “Did You Feel It?” system, indicated stronger shaking in Washington, DC, than would be expected from the Virginia earthquake.


What caused the increased ground motion in the DC area?

That’s exactly what Thomas Pratt and his colleagues aimed to find out when they installed 27 temporary seismic instruments around the DC area in late 2014. Even though there are few earthquakes in that area, the sensitive instruments recorded 30 earthquakes in the U.S. and around the world during the 10 months they were in place.

Map of Washington, DC, showing Piedmont rocks (pink) and ACP strata and other unconsolidated deposits (yellow) (Darton, 1950; Southworth & Denenny, 2006; Powars, Catchings et al., 2015, Powars, Edwards et al., 2015). The red dots show seismometer sites, the black shapes show major buildings, and the rivers are gray. AFRH = Armed Forces Retirement Home (Sherman building); CA = Capitol; LM = Lincoln Memorial; NA = National Airport; NC = Washington National Cathedral;PG = Pentagon; WA = Washington Monument; WH = White House. The red line is a cross section. (from Pratt et al., 2017)

When they examined the recordings of the earthquakes, they discovered that shaking in some parts of the DC area was amplified due to large differences between the thin layer of sediments under parts of the city compared to areas built on more solid, harder bedrock. In many cases, the parts of the buildings that were most damaged had resonant frequencies that matched the frequencies that were amplified at that location, resulting in greater damage.

Recordings of a magnitude 3.0 earthquake beneath western North Carolina at two bedrock sites (DC01 and 50 DC02) and two sites on moderately thick sediments (DC05 and DC29). Note the larger amplitudes and longer durations of the recordings at sites on the sediments. (from Pratt et al., 2017)

The Washington Monument is a particularly interesting case. An engineering study found that the resonant frequency of the 169-meter tower is about 0.3 Hz, but the pyramid at the top has a resonant frequency of about 2.5-5 Hz (faster shaking compared to the tower). You guessed it, the shallow deposits beneath the monument amplified ground motions at frequencies that nearly matched that of the top pyramid where most of the damage occurred. Similar resonant frequencies in the Smithsonian “Castle” elements resulted in the damage to specific parts such as the flying buttresses and spires.

Can shaking amplification happen in other areas?

There are many other central and eastern North American cities sitting entirely or partially on sedimentary layers underlain by older, stronger bedrock similar to the geologic conditions in Washington, DC. The scientists who performed this research presume that ground shaking amplification can occur in these other locations too. Some of these locations include Trenton, NJ, Wilmington, DE, Baltimore, MD, Richmond, VA, and Columbia, SC. Similar deposits also underlie cities in the Mississippi Valley and Gulf Coast of the U.S., notably Memphis, TN.

Shaking amplification due to soft sediments, combined with the long distances seismic waves travel in eastern North America and the large numbers of older, more fragile buildings could result in increased earthquake risk for much of the eastern U.S. and Gulf Coast regions.

-written by Lisa Wald, U.S. Geological Survey

For More Information